French Quarter

935 Chartres Street is in French Quarter, zoned VCR-2 (French Quarter residential, with somewhat higher density than VCR-1). It is in the French Quarter, where the Vieux Carré Commission reviews exterior work before it starts. The city has 3 permits on record here; the most recent, a VCC general work permit, was filed in August 2022. 3 are still open. On this block in the past year: 5 requests to 311 and 47 calls to police.

Zoning
VCR-2
Historic district
Vieux Carré (Full control)
National Register
Vieux Carre
Council district
C
Ward
5
Lot size
1,830 sq ft
Parcel
41022690

Everything on record here

3 records, newest first · 3 open

  1. Permit VCC General Work In Review

    To replace flat roofing as per materials stamped VCC approved 09/14/2022. Work includes: • Remove existing flat roofing material from main building and rear building • Install new self-adhered modified bitumen roofing in a gray or black color • Install drip edge, flashing, vent collars, etc. to match existing Note: Trash chutes are required for removal of debris from all roofs Permit does not allow for cap flashing on parapets, chimneys or surrounding walls Torch-applied roofing is not permitted in the Vieux Carré.

    Permit
    22-25730-VCGEN
    Type
    VCC General Work
    Work
    VCC General Work
    Estimated cost (applicant’s figure)
    $0
    Fees
    $0

    See this permit on One Stop

  2. Permit Renovation (Non-Structural) In Review

    Insurance company has approved new roof over property. Flat roof. Not visible from street. Only doing half of building over the address. Entire roof covers two addresses and is separated by a party wall.

    Permit
    22-25730-RNVN
    Type
    Renovation (Non-Structural)
    Work
    Renovation (Non-Structural)
    Estimated cost (applicant’s figure)
    $20,442
    Fees
    $338
    1. Application submitted
    2. Application review
    3. Zoning review
    4. Plan review
    5. Permit approved

    See this permit on One Stop

  3. Permit VCC General Work Permit Issued

    Remove deteriorated floor boards, stringers, and fascia boards. Install new 3"x4" beaded stringers, 5/4x4 T&G floorboards, and 7/8" fascia with ½" bead, all as per VCC Standard Detail Sheet No. 12 (attached). All repair/replacement work shall match existing in color, size, material, detail, profile and exposure

    Permit
    17-11871-VCGEN
    Type
    VCC General Work
    Work
    VCC General Work
    Estimated cost (applicant’s figure)
    $0
    Fees
    $0
    Days from application to issue
    0
    Expires
    Oct 6, 2017

    See this permit on One Stop