Audubon

1724 Broadway Street is in Audubon, zoned HU-RD1 (Older neighborhoods, two-family homes on smaller lots). It is in the Uptown historic district under partial HDLC control, where demolition needs HDLC review. The city has 6 permits on record here; the most recent, an electrical service / circuit / feeder permit, was filed in December 2025. 1 is still open. On this block in the past year: 9 requests to 311 and 5 calls to police.

Zoning
HU-RD1
Historic district
Uptown (Partial control)
National Register
Uptown New Orleans Historic District
Council district
A
Ward
14
Lot size
5,352 sq ft
Parcel
41044568

Everything on record here

6 records, newest first · 1 open

  1. Permit Electrical Service / Circuit / Feeder Permit Issued

    • Coordinate new service location: Meet with Entergy engineering to review and discuss the new electrical service location, verify utility requirements, and coordinate all aspects of the project to ensure a smooth installation and inspection process. • Replace existing meter setup: Remove the old meters and install a new three-gang outdoor overhead meter stack. Each meter position will include its own 125-amp main breaker for added safety and convenience. • Upgrade grounding system: Install a complete new grounding system with a low-voltage grounding bridge to ensure proper electrical protection throughout the property. • Install new feeder cables: Run new electrical feeder cables underneath the house to supply each of the three panels with reliable power. • Rear left service panel replacement: Remove the existing fuse panel and replace it with a new outdoor 125-amp, 20-circuit breaker panel, providing modern protection and easier maintenance. • Add whole-home surge protection: Install three surge protectors (one at each panel) to protect your home’s electrical system and appliances from power surges and lightning strikes. • Upgrade garage power feed: Replace the existing overhead wires feeding the garage with new #6 triplex cable for improved performance and reliability.

    Permit
    25-39697-SERV
    Type
    Electrical Service / Circuit / Feeder
    Work
    Electrical Service / Circuit / Feeder
    Estimated cost (applicant’s figure)
    $9,156
    Fees
    $40
    Days from application to issue
    22
    Expires
    Jul 20, 2026
    1. Application submitted
    2. Application review
    3. Permit approved
    4. Issue date
    5. First inspection

    See this permit on One Stop

    Placed here by the building address from “1724 Broadway St, Apartment B”.

  2. Permit Electrical Service / Circuit / Feeder Other

    • Coordinate new service location: Meet with Entergy engineering to review and discuss the new electrical service location, verify utility requirements, and coordinate all aspects of the project to ensure a smooth installation and inspection process. • Replace existing meter setup: Remove the old meters and install a new three-gang outdoor overhead meter stack. Each meter position will include its own 125-amp main breaker for added safety and convenience. • Upgrade grounding system: Install a complete new grounding system with a low-voltage grounding bridge to ensure proper electrical protection throughout the property. • Install new feeder cables: Run new electrical feeder cables underneath the house to supply each of the three panels with reliable power. • Rear left service panel replacement: Remove the existing fuse panel and replace it with a new outdoor 125-amp, 20-circuit breaker panel, providing modern protection and easier maintenance. • Add whole-home surge protection: Install three surge protectors (one at each panel) to protect your home’s electrical system and appliances from power surges and lightning strikes. • Upgrade garage power feed: Replace the existing overhead wires feeding the garage with new #6 triplex cable for improved performance and reliability.

    Permit
    25-39694-SERV
    Type
    Electrical Service / Circuit / Feeder
    Work
    Electrical Service / Circuit / Feeder
    Estimated cost (applicant’s figure)
    $9,156
    Fees
    $40
    Days from application to issue
    22
    Expires
    Jul 20, 2026
    1. Application submitted
    2. Application review
    3. Permit approved
    4. Issue date
    5. First inspection

    See this permit on One Stop

    Placed here by the building address from “1724 Broadway St, Apartment A”.

  3. Permit Electrical Service / Circuit / Feeder Other

    • Coordinate new service location: Meet with Entergy engineering to review and discuss the new electrical service location, verify utility requirements, and coordinate all aspects of the project to ensure a smooth installation and inspection process. • Replace existing meter setup: Remove the old meters and install a new three-gang outdoor overhead meter stack. Each meter position will include its own 125-amp main breaker for added safety and convenience. • Upgrade grounding system: Install a complete new grounding system with a low-voltage grounding bridge to ensure proper electrical protection throughout the property. • Install new feeder cables: Run new electrical feeder cables underneath the house to supply each of the three panels with reliable power. • Rear left service panel replacement: Remove the existing fuse panel and replace it with a new outdoor 125-amp, 20-circuit breaker panel, providing modern protection and easier maintenance. • Add whole-home surge protection: Install three surge protectors (one at each panel) to protect your home’s electrical system and appliances from power surges and lightning strikes. • Upgrade garage power feed: Replace the existing overhead wires feeding the garage with new #6 triplex cable for improved performance and reliability.

    Permit
    25-36161-SERV
    Type
    Electrical Service / Circuit / Feeder
    Work
    Electrical Service / Circuit / Feeder
    Estimated cost (applicant’s figure)
    $9,156
    Fees
    $78
    1. Application submitted
    2. Application review

    See this permit on One Stop

    Placed here by the building address from “1724 Broadway St, Apartment B”.

  4. Permit Electrical Service / Circuit / Feeder Other

    • Coordinate new service location: Meet with Entergy engineering to review and discuss the new electrical service location, verify utility requirements, and coordinate all aspects of the project to ensure a smooth installation and inspection process. • Replace existing meter setup: Remove the old meters and install a new three-gang outdoor overhead meter stack. Each meter position will include its own 125-amp main breaker for added safety and convenience. • Upgrade grounding system: Install a complete new grounding system with a low-voltage grounding bridge to ensure proper electrical protection throughout the property. • Install new feeder cables: Run new electrical feeder cables underneath the house to supply each of the three panels with reliable power. • Rear left service panel replacement: Remove the existing fuse panel and replace it with a new outdoor 125-amp, 20-circuit breaker panel, providing modern protection and easier maintenance. • Add whole-home surge protection: Install three surge protectors (one at each panel) to protect your home’s electrical system and appliances from power surges and lightning strikes. • Upgrade garage power feed: Replace the existing overhead wires feeding the garage with new #6 triplex cable for improved performance and reliability.

    Permit
    25-36160-SERV
    Type
    Electrical Service / Circuit / Feeder
    Work
    Electrical Service / Circuit / Feeder
    Estimated cost (applicant’s figure)
    $9,156
    Fees
    $78
    1. Application submitted
    2. Application review

    See this permit on One Stop

    Placed here by the building address from “1724 Broadway St, Apartment A”.

  5. Permit Electrical Service / Circuit / Feeder Other

    Scope of Work • Coordinate new service location: Meet with Entergy engineering to review and discuss the new electrical service location, verify utility requirements, and coordinate all aspects of the project to ensure a smooth installation and inspection process. • Replace existing meter setup: Remove the old meters and install a new three-gang outdoor overhead meter stack. Each meter position will include its own 125-amp main breaker for added safety and convenience. • Upgrade grounding system: Install a complete new grounding system with a low-voltage grounding bridge to ensure proper electrical protection throughout the property. • Install new feeder cables: Run new electrical feeder cables underneath the house to supply each of the three panels with reliable power. • Rear left service panel replacement: Remove the existing fuse panel and replace it with a new outdoor 125-amp, 20-circuit breaker panel, providing modern protection and easier maintenance. • Add whole-home surge protection: Install three surge protectors (one at each panel) to protect your home’s electrical system and appliances from power surges and lightning strikes. • Upgrade garage power feed: Replace the existing overhead wires feeding the garage with new #6 triplex cable for improved performance and reliability. • Remove outdated equipment: Safely remove (3) existing meter cans and risers, then install weatherproof blank covers on top of the old panels to seal and protect them. • Clean

    Permit
    25-32109-SERV
    Type
    Electrical Service / Circuit / Feeder
    Work
    Electrical Service / Circuit / Feeder
    Estimated cost (applicant’s figure)
    $0
    Fees
    $78
    Days from application to issue
    21
    Expires
    May 4, 2026
    1. Application submitted
    2. Application review
    3. Permit approved
    4. Issue date
    5. First inspection

    See this permit on One Stop

  6. Permit Electrical Service / Circuit / Feeder Other

    Scope of Work • Coordinate new service location: Meet with Entergy engineering to review and discuss the new electrical service location, verify utility requirements, and coordinate all aspects of the project to ensure a smooth installation and inspection process. • Replace existing meter setup: Remove the old meters and install a new three-gang outdoor overhead meter stack. Each meter position will include its own 125-amp main breaker for added safety and convenience. • Upgrade grounding system: Install a complete new grounding system with a low-voltage grounding bridge to ensure proper electrical protection throughout the property. • Install new feeder cables: Run new electrical feeder cables underneath the house to supply each of the three panels with reliable power. • Rear left service panel replacement: Remove the existing fuse panel and replace it with a new outdoor 125-amp, 20-circuit breaker panel, providing modern protection and easier maintenance. • Add whole-home surge protection: Install three surge protectors (one at each panel) to protect your home’s electrical system and appliances from power surges and lightning strikes. • Upgrade garage power feed: Replace the existing overhead wires feeding the garage with new #6 triplex cable for improved performance and reliability. • Remove outdated equipment: Safely remove (3) existing meter cans and risers, then install weatherproof blank covers on top of the old panels to seal and protect them. • Clean

    Permit
    25-32105-SERV
    Type
    Electrical Service / Circuit / Feeder
    Work
    Electrical Service / Circuit / Feeder
    Estimated cost (applicant’s figure)
    $0
    Fees
    $78
    1. Application submitted
    2. Application review
    3. Permit approved

    See this permit on One Stop