East Riverside
618 Peniston Street is in East Riverside, zoned HU-RD2 (Older neighborhoods, two-family homes mixed with single-family homes). It is in the Uptown historic district under partial HDLC control, where demolition needs HDLC review. The city has 5 permits on record here; the most recent, a renovation (non-structural) permit, was filed in August 2025. 3 are still open. On this block in the past year: 2 requests to 311 and 0 calls to police.
- Zoning
- HU-RD2
- Historic district
- Uptown (Partial control)
- National Register
- Uptown New Orleans Historic District
- Council district
- B
- Ward
- 12
- Lot size
- 1,719 sq ft
- Parcel
- 41047501
Everything on record here
5 records, newest first · 3 open
-
Permit Renovation (Non-Structural) Permit Issued
1-Cut out sidewalk in order to make it lower to tunnel under the house. We also have to get around the big drainpipes under the house. 2-Tunnel 5 tunnels under the house so we have access to all piping and the crawlspace. 3-Heavily spray the crawlspace with an EPA certified mold killer, Mold Stat Plus on all the wood members including the floor joists, the beams, and sills. 4-Sanitize and disinfect the crawlspace with Jo-Max and RMR on the entire crawlspace. We will use the deck brushes to scrub the crawlspace including the floor joists beams and sills. In order for the dead mold spores to drop to the 3-mil plastic so we can discard it. 5-Lay down the 6- mil vapor barrier and stake down to the earth. 6-Install a perimeter wrap around the perimeter of the subfloor to slow down the heat from escaping. 7-Lay down several sheets of plastic to capture all the dead mold spores and cart away after all the mold spores are killed. 8-Set up a 500,000 BTU indirect heater to dry the moisture out of your subfloor. We will be there every morning to fill up the diesel fuel, take moisture readings. We remove the duct work before drying out. Once the floor joists, beams, and sills are dried to lower than 10% moisture, we will be ready to spray foam. 9-Diesel fuel for the indirect heater. 10-Spray a heavy application of Bora Care on every single wooden member of the house. We have to let this dry for 4-5 days using fans. We will spray foam with closed cell
- Permit
- 25-24882-RNVN
- Type
- Renovation (Non-Structural)
- Work
- Renovation (Non-Structural)
- Estimated cost (applicant’s figure)
- $27,500
- Fees
- $260
- Contractor
- Sunlight Contractors, LLC
- Days from application to issue
- 11
- Expires
- Feb 26, 2026
- Application submitted
- Application review
- Zoning review
- Plan review
- Permit approved
- Issue date
-
Permit Solar Permit Finaled
Install a 6Kw Solar system with Micro inverters and a 40 amp double pole circuit
- Permit
- 15-34355-SOLR
- Type
- Solar
- Work
- Solar
- Estimated cost (applicant’s figure)
- $250
- Fees
- $58
- Contractor
- Riverview Construction & Consulting Service
- Days from application to issue
- 24
- Expires
- Jun 7, 2016
-
Permit Renovation (Non-Structural) Occupancy
Install a 6Kw Solar Inverter system on west roof.
- Permit
- 15-34189-RNVN
- Type
- Renovation (Non-Structural)
- Work
- Renovation (Non-Structural)
- Estimated cost (applicant’s figure)
- $20,000
- Fees
- $160
- Contractor
- Riverview Construction & Consulting Service
- Days from application to issue
- 2
- Expires
- May 13, 2016
-
Permit Certificate of Occupancy Certificate Issued No Meter
Certificate of Occupancy for Home Based Business,"PLUSH INTERIORS", as per Revenue Case #:0349. House painting/refinishing-Home office use only.
- Permit
- 10OCC-00075
- Type
- Certificate of Occupancy
- Work
- NA
- Estimated cost (applicant’s figure)
- $0
- Fees
- $190
-
Permit Electrical
ELECTRICAL VACANCY REPAIRS SINGLE-FAMILY DWELLING ANTHONY RICHARD
- Permit
- E02007041
- Type
- Electrical
- Days from application to issue
- 0