Lower Garden District
1423 Annunciation Street is in Lower Garden District, zoned HU-RD2 (Older neighborhoods, two-family homes mixed with single-family homes). It is in the Lower Garden District historic district under full HDLC control, so most exterior changes need approval first. The city has 2 permits on record here; the most recent, a mechanical HVAC permit, was filed in December 2025. 1 is still open. On this block in the past year: 21 requests to 311 and 69 calls to police.
- Zoning
- HU-RD2
- Historic district
- Lower Garden District (Full control)
- National Register
- Lower Garden District
- Council district
- B
- Ward
- 1
- Lot size
- 6,921 sq ft
- Parcel
- 41142895
Everything on record here
2 records, newest first · 1 open
-
Permit Mechanical HVAC Permit Issued
Price 1 is for the additional unit add for the proposed rear office space. This section of the warehouse will be closed off and insulated separately from he car storage warehouse. Supply and install 1 5-ton electric heat ac system. 3 phases with 15 KW of 3 phase heat. **Electrician to provide power and disconnects. Estimate includes unit, return and filter, trunk line supply duct work, thermostat, drains, no round runouts of duct work, condenser equipment rails, start up and checking. Price 2 is for 2 dehumidifiers only for the car shop in the rear of the building. includes 2 dehums, controllers, hanging material, drains, and low voltage wiring. Electrician need to provide 110v switches for power. Price 3- Added scope from phone call with owner. Supply and install2 additional equipment rails of the roof for the existing 5-ton unit that is currently on roof. Pump down AC unit and remove, install rails and secure to deck of roof. Roofer to flash to equipment rails, Rob's to reinstall the existing condenser and hurricane strap down. Break down. Equipment rails $1,250.00 -- uninstall and reinstall unit $650.00 -- Disconnect inside unit and store on site. $800.00 **customer unsure if they want to keep that existing unit on the roof. if they want to remove that unit from the roof, just the rail cost will be charged. **we recommend at the minimum, the rails be installed during the installation of the new roof so that the rails can be secured and flashed properly.
- Permit
- 25-38968-HVAC
- Type
- Mechanical HVAC
- Work
- Mechanical HVAC
- Estimated cost (applicant’s figure)
- $30,150
- Fees
- $71
- Contractor
- Robert Steven Goodwin ll
- Days from application to issue
- 2
- Expires
- Jun 19, 2026
- Application submitted
- Application review
- Permit approved
- Issue date
-
Permit Electrical Service / Circuit / Feeder Other
Supply labor and material to demo the old electrical steam and meter pan (not to damage the building or demo bricks) Supply and install a new 3 phase external meter pan, 3 phase main panel with disconnect switch, and new stem for new meter set up. (Where Entergy will hook up power) Supply new electrical feed to the existing indoor wire junction box that feeds the entire building. Indoor disconnects and panels will remain. Exceeding the scope of the permit or failure to obtain the proper building permits will result in additional fees as well as delays in issuance of a certificate of occupancy, meter release, and any other remedy allowed by law. Such remedies include but are not limited to revocation of all permits for the property.
- Permit
- 25-38689-SERV
- Type
- Electrical Service / Circuit / Feeder
- Work
- Electrical Service / Circuit / Feeder
- Estimated cost (applicant’s figure)
- $6,230
- Fees
- $100
- Days from application to issue
- 7
- Expires
- Jun 23, 2026
- Application submitted
- Application review
- Permit approved
- Issue date
- First inspection