Marlyville - Fontainebleau

3823 State Street Drive is in Marlyville - Fontainebleau, zoned HU-RD1 (Older neighborhoods, two-family homes on smaller lots). It is in the Carrollton historic district under partial HDLC control, where demolition needs HDLC review. The city has 7 permits on record here; the most recent, an electrical vacancy permit, was filed in March 2024. 5 are still open. On this block in the past year: 8 requests to 311 and 4 calls to police.

Zoning
HU-RD1
Historic district
Carrollton (Partial control)
National Register
Carrollton Historic District
Council district
B
Ward
14
Lot size
2,107 sq ft
Parcel
41189156

Everything on record here

7 records, newest first · 5 open

  1. Permit Electrical Vacancy Permit Finaled

    Electrical vacancy

    Permit
    24-05969-EVAC
    Type
    Electrical Vacancy
    Work
    Electrical Vacancy
    Estimated cost (applicant’s figure)
    $350
    Fees
    $40
    Contractor
    Charles Hilliard Scott IV
    Days from application to issue
    3
    Expires
    Sep 4, 2024
    1. Application submitted
    2. Application review
    3. Permit approved
    4. Issue date
    5. First inspection

    See this permit on One Stop

  2. Permit Mechanical Fuel Gas Permit Finaled

    6 month gas test

    Permit
    24-04848-FGAS
    Type
    Mechanical Fuel Gas
    Work
    Mechanical Fuel Gas
    Estimated cost (applicant’s figure)
    $350
    Fees
    $30
    Contractor
    William Leroy Hoffman, Jr
    Days from application to issue
    0
    Expires
    Aug 22, 2024
    1. Application submitted
    2. Application review
    3. Permit approved
    4. Issue date
    5. First inspection

    See this permit on One Stop

  3. Permit Renovation (Structural) Application Acceptance - Approved No Review

    CONSTRUCT 9" HIGH DECK IN REAR YARD PER SKETCH

    Permit
    07BLD-00142
    Type
    Renovation (Structural)
    Work
    Renovation (Structural)
    Estimated cost (applicant’s figure)
    $3,500
    Fees
    $70
    Days from application to issue
    5
  4. Permit Electrical Repair / Replacement / Addition Application Acceptance - Approved

    RECONNECT

    Permit
    06ELC-05377
    Type
    Electrical Repair / Replacement / Addition
    Work
    Repair-Replacement-Addition
    Estimated cost (applicant’s figure)
    $0
    Fees
    $30
    Contractor
    Power Electrical M
    Days from application to issue
    10
  5. Permit Repair Permit Issuance - Active

    Remove flood damaged exterior wood siding; tongue and groove interior wall paneling; sheetrock; interior and exterior doors and door frames; windows and window frames (if required); wood base and crown trims; insulation; garage door; water heater; air conditioning unit; bathroom fixtures and fittings; bathroom wall tile; floor tile throughout; electrical distribution box and wiring; gas, air conditioning and hot/cold water piping as necessary back to stud and slab condition on Lower Level. Undertake emergency blue-tarp repairs to roof. Undertake initial mold remediation. Carry out structural survey and make repairs as noted. Undertake mold and spore remediation. Undertake roof repairs to pre-Katrina condition or install new roof as required. Install brick or concrete block partition wall between garage and utility room complete with access door. Install new exterior garage door. Remove and block off two unused exterior doors to Lower Level (leaving one exterior door for emergency exit). Replace one door with window to match at rear. Install new exterior windows and window frames (if required). Install new exterior doors and door frames. Install new exterior wood siding as necessary. Install new electrical distribution box in Lower Level and re-wire complete house. Install new gas, air conditioning and hot/cold water piping as necessary. Install new insulation. Install new interior doors and door frames. Install new tongue and groove and sheet rock interior wa

    Permit
    05CIT-04384
    Type
    Repair
    Work
    Homeowner Repair
    Estimated cost (applicant’s figure)
    $80,000
    Fees
    $450
    Days from application to issue
    149
  6. Permit Residential Open

    Remove existing tongue and groove wall paneling, sheetrock, insulation and floor tile back to stud walls and slab in Lower Level. Mediate for mold and spores. Conduct structural survey. Remove existing electrical box and wiring

    Permit
    05CIT-04373
    Type
    Residential
    Work
    Homeowner Repair
    Estimated cost (applicant’s figure)
    $0
    Fees
    $50
  7. Permit Residential Open

    Remove existing flooded tongue and groove wall paneling, sheetrock, interior and exterior doors and door frames, windows, wood trims, garage door, insulation and floor tile back to stud and slab condition. Remove flooded water heater and air conditioning

    Permit
    05CIT-04381
    Type
    Residential
    Work
    Homeowner Repair
    Estimated cost (applicant’s figure)
    $80
    Fees
    $50